Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Redlands, CA
Chimney repair in Redlands usually comes down to one thing: masonry that’s spent a century baking under Inland Empire heat. Chestnut Chimney Sweep has served Redlands since 2012, and most of the repair work we schedule in 92373 and 92374 starts with cracked clay flue tiles, spalled brick, or a dried-out crown that’s let water migrate into the system. The smog and triple-digit summers here don’t create creosote problems as fast as they create mortar and liner problems. If you’ve noticed brick chips at the base of your fireplace or water stains on the ceiling near the flue, call (855) 360-4975 and we’ll put a camera up the chimney to see exactly what’s going on before anyone touches a trowel.
Why Redlands Homes Are Different
Redlands’ early-1900s citrus-belt homes, especially the historic Orange Street and Smiley Park districts, were built with original masonry fireplaces whose brick and mortar have been baked dry by a century of 100°F+ summers, so a chimney sweep here is as much masonry preservation as it is creosote removal. Those old double-wythe brick stacks were built to vent wood fires in an era before gas inserts and direct-vent appliances. Decades of thermal cycling plus the odd seismic shift mean hairline cracks in the flue liner are the norm, not the exception. That’s not a cosmetic issue. A cracked clay liner lets flue gases and heat reach combustible framing, and in a 1920s Craftsman with balloon framing, there’s often nothing but air between the chimney and the wall cavities.
The east side tells a different story. The 1960s through 1980s tract homes in 92374 trend toward prefab metal fireplaces and factory-built chimneys, which age on their own schedule. Those systems use galvanized pipe sections that corrode at the joints after forty years of heating and cooling. Santa Ana wind events load the old north-side chimney caps with citrus grove dust and eucalyptus debris, and that’s when the calls come in, because a clogged spark arrestor backs smoke into the house fast. We work with both worlds: original masonry stacks and mid-century metal flues, and the diagnosis is different for each.
Styles & brands we work with
Our Main Redlands Services
The two calls we get most from Redlands homeowners are the annual sweep and the dryer vent that’s suddenly taking two cycles to dry a load. Both are fire-safety services, and both are covered under one appointment with Chestnut.
Chimney Sweep in Redlands
A chimney sweep in Redlands means more than brushing out soot. With homes in 92373 sitting on century-old brick stacks, every sweep we do includes a close look at the mortar joints, the crown, and the flue liner condition. Creosote sits undisturbed for months in these systems because fireplaces here get used only a handful of weeks each winter, and that’s exactly what we expect to find. The sweep is thorough, but the inspection is what catches the liner crack before it becomes a chimney fire. Chimney Sweep in Redlands covers the full process, including what we find most often in the older neighborhoods.
Dryer Vent Cleaning in Redlands
Dryer vent cleaning in Redlands matters more than most people think, because lint accumulation is the leading cause of dryer fires and the Inland Empire’s dry air makes lint even more combustible. If your dryer’s taking 90 minutes to dry towels, the vent is telling you something. We pull the dryer, clean the full run from the appliance to the exterior termination, and check the termination flap for eucalyptus debris and dust from the citrus belt. This is a Famco-grounded fire-safety service, not a ten-minute add-on. Dryer Vent Cleaning in Redlands has the details on how we do it and why it’s scheduled as its own job.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Redlands
Chimney repair in Redlands concentrates on two failure patterns. The pre-1930 brick chimneys in the historic districts fail from the top down: the crown cracks, water gets into the brick, and the freeze-thaw and heat cycles finish the job. The 1960s through 1980s metal chimneys on the east side fail from the inside out: the galvanized liners corrode at the seams, and the technician finds flaking metal the first time the camera goes up. Chestnut’s approach is to diagnose with a camera, specify the right repair product by name, and never recommend a liner or crown repair without showing you the footage. Our Chimney Repair hub page covers the full scope of repair work we do, and what follows are the specific jobs we handle most in Redlands.
Chimney Cap Installation
In Redlands, a cap does double duty: it keeps rain out of the flue and keeps Santa Ana-driven debris from packing into the spark arrestor, which is the most common call we get after a big wind event on the north side.
Signs you need it
You have no cap at all, or the existing cap’s mesh is peeling away and you’re finding eucalyptus leaves and twigs on the fire grate or on top of the damper.
What it costs in Redlands
Chimney cap installation in Redlands typically runs $200 – $400 depending on flue size and whether we need a custom bracket for an odd-sized clay tile crown.
How we do it
We measure the flue opening, select a stainless or copper cap sized for the tile, secure it with a mechanical fastening system, and test the draft so the cap isn’t choking the fireplace’s air supply.
Chimney Cap Replacement
When a cap’s survived twenty years of Inland Empire sun and wind, the mesh usually rots out while the lid is still standing, and that’s the moment to swap it before the flue becomes a birdhouse or a debris trap.
Signs you need it
The existing cap is rusted through at the seams, the mesh has holes a sparrow could fly through, or the cap’s been lifted or dented by a Santa Ana gust and water’s now getting into the flue.
What it costs in Redlands
Replacing an existing cap in Redlands runs $200 – $450, with copper caps at the higher end and standard stainless caps at the lower end.
How we do it
We remove the old cap, wire-brush the flue tile rim, set the new cap with a secure mechanical mount, and verify the spark arrestor mesh is intact and seated.
Chimney Liner Installation
A liner installation is the single biggest chimney repair decision a Redlands homeowner makes, so we show you the camera footage before quoting a single number. If the clay tiles are cracked or the old metal liner’s flaking apart, the fix is a new DuraFlex stainless liner sized to the appliance and to the flue’s actual dimensions.
Signs you need it
You’re finding water in the firebox after rain, you can see pieces of clay tile on the smoke shelf, or the camera shows gaps and offsets in the old liner that would leak flue gas into the house.
What it costs in Redlands
Chimney liner installation in Redlands typically runs $800 – $1,400 for a standard single-story home, which includes the liner, insulation, top plate, and crown seal, though taller stacks and multi-flue jobs push that higher.
How we do it
We run a sizing camera up the flue, pull and prep the liner, feed it down through the crown, connect it to the appliance connector, insulate the annular space where code requires, and seal the top with a cap and crown plate.
Chimney Flashing Repair
Flashing is the metal seam where the chimney meets the roofline, and on old Redlands homes with steep gable roofs, it’s the first place water finds a way in. We replace it, we don’t caulk it and cross our fingers.
Signs you need it
Your ceiling or attic shows water stains near the chimney chase, or you can see daylight through the gap where the counter-flashing’s pulled away from the masonry.
What it costs in Redlands
Chimney flashing repair around Redlands runs $300 – $600 depending on roof pitch and the number of flashing planes, which is a fraction of what the water damage underneath will cost if it’s left.
How we do it
We cut away the old flashing, install new step and counter flashing with a proper reglet cut into the mortar joint, and seal the top edge with a high-temperature masonry sealant that can handle the thermal movement of that old brick.
What Chimney Repair Costs in Redlands
| Item | Typical range in Redlands |
|---|---|
| Chimney cap installation | $200 – $400 |
| Chimney cap replacement | $200 – $450 |
| Chimney liner installation | $800 – $1,400 |
| Chimney flashing repair | $300 – $600 |
The price range reflects the difference between an easy single-story cap swap in 92374 and a full liner pull on a two-story 1920s stack in 92373. Chestnut quotes flat pricing before we start, so the number we give you is the number you pay.
Do I really need a new liner, or can the old one be repaired?
It depends entirely on what the camera shows. If the clay tiles have minor surface checking, HeatShield restoration can often add years to the liner without a full teardown, and we’ll show you the footage before recommending either route. If the liner is fully cracked through or previous repairs have already failed, replacement is the only safe option. Call (855) 360-4975 and we’ll give you a straight answer with pictures to back it up.
How long does a chimney liner installation take in Redlands?
A standard single-story liner installation is usually completed in one day, including the camera inspection before and after the pull. Two-story homes or multi-flue chimneys may run into a second morning, and we’ll tell you which it is when you book. We don’t leave a Redlands home without firing the system and confirming the draft is correct.
Brands We Service in Redlands
We run a curated parts roster, not whatever’s on the shelf at a hardware store. DuraFlex liners, HeatShield restoration materials, and Olympia Chimney caps are what we stock and install in Redlands, because the parts matter as much as the labor. See our brands for the full list of what we carry. Most common parts are on the truck, so we’re not scheduling a second trip for a cap or a flashing kit.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Redlands, CA
| Service | Typical range in Redlands |
|---|---|
| Chimney cap installation | $200 – $400 |
| Chimney cap replacement | $200 – $450 |
| Chimney liner installation | $800 – $1,400 |
| Chimney flashing repair | $300 – $600 |
| Chimney crown repair | $150 – $500 |
What pushes a Redlands chimney repair toward the top of those ranges is roof pitch for flashing work, flue height for liner work, and the general condition of the mortar joints we’re anchoring to. If the brick itself is spalling, the repair scope grows. Chestnut gives you a flat quote before we start, and the number on the quote is the number you pay.
Neighborhoods We Serve in Redlands
We’re running calls across all three Redlands ZIP codes every week. The historic districts take the most masonry-repair time; the newer tracts on the east side keep us busy with prefab flue and dryer vent work. We schedule Redlands jobs by zone rather than by calendar roulette, so your appointment window holds.
- Orange Street / Smiley Park (92373) – the century-old brick stacks, caps, and crown work
- South Redlands / Sunset Drive corridor (92373) – Spanish Colonial and Craftsman masonry
- East Redlands (92374) – 1960s through 1980s tract homes with prefab fireplaces
- North Redlands / Lugonia area (92374) – Santa Ana-drifted debris issues
- Redlands Heights and the university corridor (92375) – mixed-era chimneys and dryer vents
Service Area – Cities Near Redlands
Chestnut Chimney Sweep runs the same trucks and the same name-brand parts to the communities around Redlands. If you’re in Mentone, CA, Loma Linda, CA, Highland, CA, or Colton, CA, you’re within our regular service rotation, and we’ll schedule you the same way we schedule a Redlands job: with a camera inspection, a flat quote, and no surprises.
Serving Redlands, CA — Our Local Coverage Area
We’re based in the Redlands area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Redlands
Most Redlands repair calls can be scheduled within a week, and if you’re seeing active water intrusion through the chimney chase or have a visible liner failure, we’ll move the schedule to get a camera up the flue faster. The inspection always happens first, so by the time we quote the repair, we know what we’re fixing. Call (855) 360-4975 and we’ll give you the next available window in your ZIP code.
Simple repairs like cap replacement, crown sealing, and flashing work don’t require a city permit in Redlands, but a full liner replacement or any structural alteration to the chimney chase may. Permitting rules vary by project scope, and we’ll tell you during the inspection if your job requires one. We don’t charge for a permit consultation, and we’ll handle the paperwork if it comes to that.
A sweep cleans the flue; a repair inspection tells you whether the flue is still safe to use. Most Redlands homes need both, especially the pre-1930 masonry stacks, because a clean flue with cracked clay tiles is just as dangerous as a dirty flue with solid liners. Chestnut does both in one appointment, and the camera footage from the sweep feeds directly into the repair recommendation. Nothing gets quoted without pictures.
If your Redlands chimney hasn’t been looked at in years, or your dryer’s been running two cycles on every load, call Chestnut Chimney Sweep at (855) 360-4975. We’ll put a camera where it needs to go, show you what we see, and quote the job flat before anyone starts work. Clean flue. Safe home. Done right.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Redlands Customers Say
"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Andres Morales"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Allen Nguyen"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Marisol Salazar